Rob - Yeah I get the general idea and it's a good one. Not sure if it would work for what I'm doing using the ground to activate, I'll have to think about that one a bit. Apache good idea on the foot pushbutton, that is kinda a pain to back up with them on the wheel. Robert -hey if you want to throw that one you have in the truck with you tonight I might be interested in it and could check it out at MoKan. Not sure if it'll work or not, it's got to be pretty stretchy to reach my hook for the steering wheel though. HPDrifter - I'm going to be in Wichita Sat, I might swing by the Yard store and look. Install the TCI solenoid over the new brake valve. Use the stock modulator retainer and bolt to hold it in place. Use the stock modulator retainer and bolt to hold it in place. INSTALLATION PRODUCTS. SEE REVERSE SIDE FOR WIRING DIAGRAMS. Hold the trans brake switch and flip the safety switch to 'Delay'. Man it's been forever since I was in that place, I'd like to go sniff around there at bit. 'HPDrifter - I'm going to be in Wichita Sat, I might swing by the Yard store and look. Man it's been forever since I was in that place, I'd like to go sniff around there at bit' If you go - in the main building, walk past the checkout area and about half way to the west side of the building. Turn right and walk to the north end of the shelves. The cords, some with the clamps I mentioned are in a short cardboard barrel at the north end on one of the rows. $.75 each if I remember correctly. The clamp alone is worth that; but the cords have four very small wires for a microphone or something. No heavy enough for a trans brake solenoid. Trigger them off of the same ground signal (sent when you push the button). I'm terrible with wiring.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2018
Categories |